Why Vancouver Businesses Choose Us

You want an appliance repair company who shows up on time, explains what’s happening in plain English, and leaves your laundry room humming. That’s us. Our techs are manufacturer-trained, fully insured, and equipped for on-the-spot repairs. We document everything we do, from fault codes to part numbers, so you have a paper trail for operations and compliance. No surprises, no vague “we’ll see.”

 

What we service

From coin-op to on-premise laundry, we handle the full spectrum of commercial washers used in Vancouver hospitality, healthcare, multi-res, and laundromats.

• Hard-mount and soft-mount washers, 20–200 lb

• OPL machines, coin and card-op, stackable washer-dryer units

• High-G extraction, inverter-driven units, steam or electric heat assist

• Ancillaries like pumps, drains, valves, soap systems, controllers, and card readers

 

Common commercial washer problems we fix

A slow spin or a mystery leak is more than an annoyance. It’s lost throughput and higher utility costs. Here’s how we zero in and solve.

• Not draining or frequent “drain error”

Likely causes: blocked pump trap, failed drain pump, kinked or clogged hose, board not energizing the pump. We isolate power at the pump, bench-test flow, and clear or replace components.

• Won’t reach full spin, loads stay wet

Causes: unbalanced load detection, worn belt or bearings, faulty tach sensor, weak inverter drive. We check suspension, run no-load spin tests, and scope drive output for clean frequency.

• Leaks on fill or mid-cycle

Causes: door boot tears, loose clamps, cracked tub hose, leaking inlet valve bodies. Dye testing and pressure checks help us pin it down fast.

• Door lock errors, won’t start

Causes: failed lock assembly, broken strike, harness damage, or board logic fault. We test lock ohms and board outputs before replacing anything.

• Over-sudsing, residue, odor complaints

Causes: incorrect chemistry or dosing pump calibration, low-temp programs, biofilm. We recalibrate chemical pumps, run sanitize cycles, and set program standards with your team.

• No fill or slow fill

Causes: screen clogs from sediment, bad fill valves, low supply pressure, faulty flow meters. We check static pressure, clean screens, and validate flow rates against spec.

• Vibration and walking

Causes: out-of-level bases, worn shocks or springs, cracked anchors. We level to spec, torque anchors, and replace suspension to protect bearings and floors.

If a repair risks recurring downtime or outstrips machine value, we’ll say so and recommend a plan that protects your budget.

 

Our repair process

1. Quick triage on your call or form: symptoms, model, error codes, business impact.
2. Dispatch the right tech with probable parts based on your machine family.
3. On-site diagnostics with clear findings and a firm quote before work.
4. Repair and validation wash: we test drain, fill, heat, extract, and leak points.
5. Proof of fix: photos, codes cleared, part numbers, and maintenance notes.
6. Follow-up: warranty details, care tips, and reminders if a secondary issue is likely.

 

Preventive maintenance that actually prevents

A 30-minute PM can save hours of downtime. We offer quarterly or bi-annual PM designed for Vancouver water and usage patterns.

• Clean and inspect pump traps, inlet screens, and chemical lines
• Check belts, bearings, shocks, and seals for wear before they fail
• Calibrate chemical dosing, verify temperatures, and update programs
• Inspect anchors and leveling to reduce vibration and bearing stress
• Lint and drain checks that keep you compliant and flood-free

Sectors we support

Hotels and short-stay, care homes and clinics, gyms and spas, student housing, property managers and strata, laundromats, uniform and linen services, and marine or remote sites that need dependable turnaround.

GET A QUOTE NOW:

Commercial Washer Repair Vancouver FAQs